Why can’t you use “loop through” wiring for DIRECTV?

If you have an existing cable or headend system, and want to switch to DIRECTV, you might have been told that the “loop through” wiring that you have won’t work. You might have been told that you need “home run” wiring. Loop through wiring, also called series wiring, is where you run one line from the headend or rack, and then use a splitter or “T” to drop a cable to each TV. It’s an easy, cheap way of wiring.

Home run wiring

Home run wiring has nothing to do with the home and it has nothing to do with baseball. The term means that every television or receiver has a dedicated line back to the distribution closet. Traditionally, hotels and other cable installations have been done with loopthrough (also called series) wiring. Changing over to home run wiring can be expensive and time consuming and there isn’t a lot of understanding why it’s necessary.

In order to understand the need for home run wiring, it’s important to understand the actual difference between home run wiring and series wiring. In order to do that, you must first understand the difference between a splitter and a tap.


A splitter takes a single line and splits the current equally to multiple outputs. Look at the image on the left. The red line is current going in, and it is split evenly to all the outputs. The result is the green lines, which are all thinner than the red line. Each output on a splitter carries less current but every output carries the same current.


On the other hand, a tap does not equally split the current. One output will be much stronger than the other, as shown in the image on the right. The intention is that the stronger line goes on to be “tapped” again, while the weaker line serves the TV or receiver to which it’s connected. In this way, the strongest possible signal can reach the end of the line.

Series (loop-through wiring) is great but…

The advantage of series wiring is that it’s cheap. Running a line to 8 TVs will require one long line and 8 short lines. Using home run wiring in the same situation requires 8 long lines and that’s a lot of copper. However, series wiring has one major limitation: a failure at any point in the line affects everything “downstream” of it. It’s kind of like Christmas tree lights in that breaking the line anywhere will cause the entire string of lights to go out.

Series wiring is cheap to put in, but in a case where you’re pushing a big, fat digital signal down the line it just isn’t reliable. It also creates problems where you need two-way communication. This is the case in most modern satellite installs. Think of home run wiring this way: The splitter is downtown, and there are 8 roads leading out of town, one to each house. To get downtown is easy: one road. Now think of series wiring. If you’re on a long road with 8 intersections, and you don’t know which one of them leads downtown, it’s going to take you a lot longer.

Home run wiring is better for satellite

Home run wiring is easy to put in when you’re doing the initial install but it can be hard pushing 8 wires into a conduit designed for one. That’s why people like commercial headend systems. In apartment buildings, home run wiring is really the only way to go because you don’t want people affecting their neighbors if they add a new TV. In the case of a bar or restaurant, there are plusses and minuses. Home run wiring’s cost is usually lower. With home run wiring, you don’t have to use a matrix switch or modulator, and it will allow for ultimate flexibility because every TV can have unique programming.

About the Author

Stuart Sweet
Stuart Sweet is the editor-in-chief of The Solid Signal Blog and a "master plumber" at Signal Group, LLC. He is the author of over 8,000 articles and longform tutorials including many posted here. Reach him by clicking on "Contact the Editor" at the bottom of this page.